In many cases, combinations of vibratory screening and settling/centrifugal force are used together to provide an effective separation.
The most familiar combination separator is the Mud Cleaner. See picture on next page.
Mud cleaners were developed in the early 1970s to remove fine drilled solids from weighted mud without excessive loss of barite and fluid.
They have also proved valuable tools in closed systems and other dry¯ location¯ applications.
These devices use a combination of desilting hydrocyclones and very fine mesh vibrating screens (120-400 mesh) to remove fine drilled solids while returning valuable mud additives and liquids back to the active mud system.
Traditional mud cleaners use multiple 4¯ or 5cyclones, mounted over a vibrating screen, and are able to effectively process 400-600 GPM.
The process capacity is limited by screen capacity and its ability to discard dry solids.
With the introduction of linear motion vibrating screens, the capacity of the mud cleaner screen has been greatly increased.
This, in turn, allows the use of additional hydrocyclones and higher, overall process capabilities.